Intel D915GAVL Motherboard "power down" Questions

power down I have an AK73 1394 Mother board and an AMD processor. The symptom is: It initially powers up when I press the on button but about 2 seconds later it powers down by itself. I then cannot ...

...power down. If I attempt to install Windows XP on a brand new SATA HDD from the Windows XP CD it powers down in the middle of the process. I am pretty sure it has something to do with the BIOS but I ...

...motherboard. unplug the power switch wire and bridge the 2 pins together, this will start the computer. then power down and if it shuts down properly then clean or replace the switch. Regards ...

...power down. Unplug the power cord from the Power supply. Then hold down the pc power button. Try to boot the pc. 2. Open the case and reseat the graphics card, hard drive, and RAM. 3. Take out one of ...

...Power On wire. (PS_ON) ANY Black wire you see is a Ground wire. A jumper wire is used to make a Momentary contact from the Green wire, to ANY Black wire. Observe the photo to the far Right. Where the ...

...i help you? Friend if you put something like usb or etc.it shut down. the problem is your power supply.your power supply dont have enough power to gve the new installed device thats why it shuts

power shuts down I have Wolfdale 1333-D667 motherboard that will shut down after a minute even with only CPU, Monitor, Memory connected. It does not post. It was working fine then started to shut down

...down and the power button does function. I have tried a complete shutdown (in the dock). Ejecting and trying to start it undocked - without success. Try removing the laptop from the doc, pulling out ...

...power down to stop the cpu from buring out. A power suppluy just supplies power to the motherboard and that's it. If the CPU gets hot it shuts down and wont start till it cools down again. ...

...and ensure that when you click turn off the pc is instructed to power down. ACPI is set on in the CMOS and there is no option in control panel power options to turn off PC to power down. I am using ...