Question about Hyundai Audio Players & Recorders
I need to install the seat cover. Phillip, Replacement Seat Assembly Replacement 1.Remove the rear seat cushion assembly. 2.Remove the rear seat back assembly. 3.Installation is the reverse of removal
...but does not charge the battery. Sounds like the battery may have come loose in the inside. You can unscrew the back and remove and re-seat the battery, then try charging it again. Best of
...for 60 seconds and re-seat it back in place hopefully this will reset the processor ic, if this fails take it back because there is nothing more that can be done since the item is under
Question about Hyundai Audio Players & Recorders
...because I get the same error message every time I plug it in. Try removing the battery from the back and re-seating it. They become loose if they are dropped, or handled roughly. Best of
back cover to the left) Look for the ribbon connector that connects the display to the circuit board. (it's about 1 inch wide) Lift up on the black part of the connector to release the ribbon. Pull it
...back, remove and re-seat the battery. Charge the device for a few hours. Best of Luck. p.s.- you can add to this question if this didnt help. i did this and it almost work up to the point where the ...
...seat it back in place on the board and hopefully this will fix it, because a fall can knock it out of position making you think it is plugged in and okay. Now! if this fails you may need to replace ...
Question about Hyundai Audio Players & Recorders
back cover to the left) Look for the ribbon connector that connects the display to the circuit board. (it's about 1 inch wide) Lift up on the black part of the connector to release the ribbon. Pull it
...not the ones mounting the plastic frame) remove 2 screws on side of unit(not all four, tough to get back together if you do. take ribbon and reset it into hard drive first, then unit. slide battery ...
...screws holding circut board and lcd (Set aside seperat from other screws as shorter and must go back samme place. Fingernail out whit clip over usb port and set aside. Lift entire circutboard/lcd ...
3 questions posted
Usually answered in minutes!
14 Questions
11 Questions
2 Questions
8 Questions
9 Questions