Pitco Frialator 35CS Deep Fryer "hi limit" Questions

...hi-limit switch and still use fryer? You will not be able to use the fryer if you disconnect the hi limit. Never attempt to put jumper wire across the hi limit terminal because hi limit on fryers or ...

hi-limit switch will only pop-out when its sensing bulb sensed temperature higher tha 450F (trip temperature of hi-limit). Theramostat may be bad allowing oil to reach temp above 450F causing hi-limit

...hi limit. I replaced Hi Limit, Thermopile and Thermostat and it worked great for two days and then kicked out again, tripped Hi Limit. I'm baffled as to what else it could be. I was told to ...

...hi limit mechanical contacts. Hi limit on fryers act as safety device which will shut down pilot and burner flame when oil temperature reaches 450F. If your fryer is set at 350F and over shoots up to ...

Hi-limit trips, How it works and how to trouble shoot? jump the hi limit by connecting the two wires in the back of the limit control after 45 minutes with the fryer on and does not go off the limit ...

...hi-limit may be as well. I could give you instructions on calibrating the thermostat but the hi-limit is not adjustable at all. The hi-limit cuts off the burners and pilot in the event that the unit ...

...hi-limit thermostat is tripping. That could be the result of the hi-limit thermostat being faulty or the thermostat is faulty and the oil is actually too hot eg: 450F. Once this is determined, either ...

...Hi-Limit thermostats, carbon build up on burner tubes, and dirty or clogged burners. This hi-limit thermostat is mounted inside the fry tank on one of the burners. Often the cappillary tubes are ...

...hi limit and thermostat and the fryer still cutting out at certain temp. Seems like when it hits 400 it will cut out. What could be the issue? Do we need to lower the temp? I really need it at 400. ...

...Hi-limit or the thermostat? I can turn on the pitco fryer.But it trips around 200 degree and I can't turn it on until the temp goes down. What's the problem? Do I need to check the ...