Pitco Frialator SG14 Deep Fryer "hold pilot light button" Questions

...hold the pilot "lite" button down long enough for the fryer to light.  We normally instruct them to hold the pilot lite button in for some time, then light it, and after it lights, turn ...

Hold the button down, and it should be in pilot position first. Once it's lit, then to ON. Does yours have a pilot or just ON? If you only have ON, then it should be turned to there... Susan @

...should control the fryer. If your pilot does not stat lit, press the red button on the hi-limit to reset it, it could be tripped and this would cause the pilot to not hold. Hope this is

...hold until you can light the pilot using a lighter (this may take several minutes, to bleed the air from gas supply) once there is a pilot flame present, you will need to hold the valve button in for ...

...hold in the g/v button and the pilot will stay on but then go off when you let the button go you have a bad thermocouple. The 2nd is another option possibly installed on your fryer which is a pilot ...

...hold the pilot light button , the thermocouple will normally reach enough temp to keep valve open. If the termocouple is faulty, it will turn off as soon as you release the igniter button. Replacing ...

...pilot to light just hold a lighter and the pilot lights in either the pilot or on position. Second when I light the pilot and turn the temp up the pilot goes right out and burners don't ignite. Any ...

pilot, and press and hold it down, put flame to pilot and release button when flame is self standing... Then turn to on position. If you have other issues, call the Vulcan company themselves, and they

hold down the light pilot button long enough for the sensors to heat up, to tell the pilot to light.... That's our number one complaint, and number one service call, and it's almost always the

...pilot flame does not hold after releasing the button for at least 20 to 30 seconds, try to clean the thermopile and tighten all wiring connection on gas valve, thermostat and hi limit the repeat the ...