...that came to your house would do this or test for 120 volts at the ignitor with the oven turned on. Not saying this is your problem, but it is most common repair, and easiest place to start, good ...
oven will not heat up. The orange ignitor light comes on but temp stays at 100 Hello, welcome to FixYa. Based on your description, I`d suggest the hot surface ignitor for the bake burner is likely the
...oven, pull the two wires off the valve and ohm test. Should read two to five ohms. If open, replace valve. The pilot is out?DUH! Try reigniting the pilot. If it goes out again, check 1) gas supply ...
...test for it. 1. Check the oven temperature sensor. The oven sensor has to be within spec or it will cause the F1 code. As an example of being out-of-spec, the ERC will generate an F1 fault code when ...
...test your igniter for free. When the igniter is on it should glow very brightly. If it is dim then that is a sure sign it is bad. You can also verify that the oven run-away valve is not closed. This ...
Question about Whirlpool Kitchen Ranges
ignitor wire has gotten pinched between the side panel and back bulkhead causing intermittent ignition. The gas valve part number is 8054079 and is #15(bottom right) in the exploded diagram if needed.
...test your igniter for free. When the igniter is on it should glow very brightly. If it is dim then that is a sure sign it is bad. You can also verify that the oven run-away valve is not closed. This ...
...test your igniter for free. When the igniter is on it should glow very brightly. If it is dim then that is a sure sign it is bad. Also inspect the burner venturii and burner orfice for any possible ...
Question about Kitchen Ranges
oven. There usually will be a heavy steel flame shield held on by a single nut underneath the cover. Remove this shield. This will expose the ignitor(called a glow bar). One of the classic symptoms of
299 questions posted
Usually answered in minutes!
68 Questions
72 Questions
46 Questions
31 Questions
