...stove top. Carefully note the position of the old module and label the wires so you can put them in the new module correctly. There should be 2 or 3 screws that are holding the old igniter module in ...
...stove. Now you are safe! With a phillips screwdriver, remove the backpanel. The switch you are replacing, remove knob. Remove the two screws that hold the switch in place. When switch is free, remove ...
...put off the power supply connected to the stove from the wall, then get your self tools i.e the basic tools to unscrew the screws around the stove ,then trace the wire that connect power to the stove ...
...your thermostat or get someone to do it and all will be ok, or just turn off cooker on wall switch and only switch it on when you need it, that's if you can put up with it and need to save ...
...that unit. Back in the day most electric stoves were hardwired at the wall, so I would say to look at the model number plate and just see that it is a 220 volt stove before you put a plug wire on
Question about Frigidaire Kitchen Ranges
...stove but goe's well Unplug the range from the wall first. Just raise the cook top and the elements are attached to the bottom of it, probably by four screws. Note how the wires are plugged in then ...
stove. However, replacement part has two extension whereas the old part has three. I am little confused on where to put everything. I see that the yellow wire goes under the bottom of the valve on the
Question about KitchenAid Kitchen Ranges
...stove before you work on it,go here to see picture of module https://www.repairclinic.com/PartDetail/Control-Module/WPW10331686/1937904 also you can go here to sears site,put your model number in and ...
Question about Electrolux Kitchen Ranges
put a plug on the stove. Do we need to cut a hole in the wall and take out the plug and hard wire the unit into the electricity. Elaine We have the same Electolux range.....it is supposed to fit about
...put a piece of plastic or cardboard under the test leads to isolate the leads from the bottom of the oven. Once connected and properly isolated, plug stove in, turn stove on to bake 350 degrees and ...
119 questions posted
Usually answered in minutes!
231 Questions
68 Questions
46 Questions
31 Questions