...water stops flowing. Could this be a bad solenoid valve. Part # 32001639-002. Turning the heat on immediately causes the water to start flowing again. Its as if the solenoid is stuck in the open ...
water flowing. Even setting to "test/reset" doesn't do it. I have looked at the orifice after the solenoid and it is fine as is the water inlet hose. Any ideas? Thanks the humidistat on this unit just
...water to begin flowing..now, after the "click" is heard, the water does not flow into the reservoir. Do you think it's the humidistat or the solenoid? Thank you turn the saddle valve in and back out. ...
...water from solenoid. The humidstat is a '56'. Won't work in 'test' position. Outside sensor is hooked up to humidistat: The following voltage checks were performed:( while on and demanding heat): - ...
700. The water runs constantly while the furnace is on despite what the humidistat is set to. Can you give me some tips on how to fix? Can you turn off the water flow with the humidistat is set to off
...water line and turning the humidistat all the way up. You should hear a click as the solenoid tries to open. If it clicks and no water comes out it's the valve. If there is no water to the valve, ...
...Humidistat not turned up high enough Water valve not opened Bypass damper not opened 115 volt unit not plugged in Completely clogged water panel or pad Wheel/humidifier pad installed in motor ...
...it started to work. Does this mean that the humidistat is bad? The water supply get to the solenoid and after I jumped the humidistat, it started to flow into the unit. HI sounds like you have found ...
...wired in series. If the water stops flowing when the voltage is not on, but water flows when energized then your solinoid IS GOOD and you must check your humidistat and furnace electrical
298 questions posted
Usually answered in minutes!
180 Questions
155 Questions
31 Questions
4 Questions
2 Questions