Question about Samsung CLP Office Equipment & Supplies
...replace transfer roller soon" - Any ideas As my waste tank was so full and so used, just emptying it was not sufficient to remove the "waste toner full" message. So after fully emptying the tank, I ...
Question about Samsung CLP Office Equipment & Supplies
water. He suggested alcohol (which I used). I scrubbed it all over the paper-facing, curved surface. (Turn power off, remove toner cartridges, remove imager assembly--out the front, remove paper tray,
Question about Samsung CLP Office Equipment & Supplies
...a slot on the bottle goes" Clean with a cotton bud a small amount of bleach with water, or methylated spirits will do, also clean both sides of the slot on the bottle, then replace. ...
...a slot on the bottle goes" Clean with a cotton bud a small amount of bleach with water, or methylated spirits will do, also clean both sides of the slot on the bottle, then replace. ...
...Water only is fine, rubbing alcohol if they're bad) Also look for a seperation pad, this will be a rubber or cork pad under the rollers. Clean this as well and if it's worn, replace. 2) A ...
Question about Samsung CLP Office Equipment & Supplies
...replace the pickup roller: CAUTION: Failure to complete this procedure might damage the printer. Unplug the power cord from the printer, and allow the printer to cool. Figure 1: Unplugging the power ...
Question about Minolta Office Equipment & Supplies
WATER OR WET RAGS to cleanup use a brush. Add your new developer. One Bag only. Reassamable. Now for the Drum. Remove both side covers one side has small plasitic been so be careful. Reove drum remove
...water with ammonia. Hope that fix your printer problem. the waste ink counter is probably not resetted, Try resetting the couter for the waste ink, or reset the hole printer to factory default ...
...water. Re-attach the rear access panel.. Print test page using the printer itself (press and hold the OK and HELP buttons on the front panel of the printer, until it starts to print a test page, then ...
front cover. b. Remove the old drum unit and toner cartridge assembly. Place it on a drop cloth or disposable paper to avoid scattering toner. NOTE: Be careful not to spill the toner. If toner gets on
133 questions posted
Usually answered in minutes!
951 Questions
374 Questions
221 Questions
110 Questions
74 Questions