Question about Dynamo Audio Players & Recorders
...auto or standby does not turn the power or the hum off. Now the strange part. Attach speaker cables and sens a signal to the Dynamo and it sounds great. Terrific bass and no hum at all, even during ...
...Power Mode (rear-panel): This switch can be set to either On, Off, Auto. If the switch is in the Off position, the subwoofer will not power up. If the switch is in the On position, it will constantly ...
...power failure (electricity incoming ) and then when I resumed, it was not working. Tried auto setp but shows E7 error (internal system error) as advised, I tried Factory preset and again autoset up ...
Question about Cerwin Vega Audio Players & Recorders
...help? There's a jumper on the amplifier board inside the speaker which can be set to "off", "auto", or "on" Default is auto which turns on the speakers when an input signal above a ...
...auto'. It stops thumping when I switch the sub power off. Also, it only thumps once I turn up the gain, otherwise there is no sound coming from the sub. I am pretty sure its not my receiver. It must ...
Question about Audio Players & Recorders
...Why won't our Energy Powerbase stay powered off? if the auto power feature is turned on, then anytime the base sneses an input signal, it will turn on. turn this feature off and you should be
Question about Polk Audio Audio Players & Recorders
power cord there is a round modual that you can unscrew. once unscrewed you will see a fuse in there. make sure it has not blown. if that is not it make sure the sub is switched to on and not auto. on
...last week. It's powered up and everthing but not throwing any bass. It was also detected during the auto setup. If you're saying the auto setup produced sound then the sub and its amp are fine. So we ...
...bar when I turn tv back on, is there a way to set it up so it turns on and off with the tv power there should be an "auto power" feature that should turn the unit back on once a signal is
Question about Yamaha Audio Players & Recorders
...auto on/off is off I just fixed one of these with the same symptom.In between the power supply board and the amplifier board are a number of rather fine interconnect wires. One of these is the ...
0 questions posted
Usually answered in minutes!
2 Questions
1 Questions
1 Questions
1 Questions