1986 Toyota Hilux 2200 "put crank shaft timing gear" Questions

...crank shaft gear to TDC on the timing marks OR you have both marks on the gears and you line them up with each other using a straight edge through the center of the shafts, then you put the chain

...CRANK SHAFT GEAR I FOUND THE MARKS CAM SHAFT the timing is set to 8 degrees at 700 rpm...if it helps any Are you putting in a new timming chain? If so it should have came with a new crank gear witch ...

...put you finger over the hole, crank the engine untill the pressure pushes your finger off, then put a stiff wire in the hole and turn the engine by hand (wrench) untill the wire comes up and just ...

Put the timing belt on the crank shaft pulley first, and after on the overhead cam pulley. Release tensioner and rotate the crank shaft till the timing belt makes two full circles. Try to align marks,

...put timing belt on 1997 mercury tracer 1.9 l and 2.0 l are the same remove fan belt and remove belt tensioner remove timing cover (2) 10 mm nuts rotate to TDC a small "o" on lower gear and round hole ...

...put the cam shafts in position or you will bend valves. Crank shaft gear is not keyed to the crank shaft. there are dots on the right hand balancer shaft gears and these dots will be as the 2 dots on ...

...Put #1 cyl. t.d.c with crank. timing mark pointing @ center of the chain tensioner bracket. Remove cam shaft pulley remove chain, reinstall pulley(no chain) and turn cam shaft until cam shaft mark ...

...put together the single tooth marked on the drive gear must fall into the grove marked the the 2 dots on the cam gears. If you are just trying to time an engine, the belt drive pulley mounted to the ...

be keyed so the gear cannot be wrong. Look for a mark on the gear and one on the head. Line those up. On the crank shaft use the timing mark and guide and line up to TDC or 0 and put the chain back on

...crank has a dot stamped on it, gear for cam also has a dot stamped on it. when all is put together, the two dots must align with each other at the closest point of rotation. Here is a link that shows ...