2005 Opel Corsa "temp gauge maxed engine hot" Questions

Temp gauge hot engine not Temp gauge read max. hot but engine is not hot More than likely the tiny DC motor in the gauge cluster is defective, a common issue on this truck. Pull the cluster and have ...

temp gauge is not working Find the wire to the temp gauge sensor on the block of the engine. Unplug the wire and check your gauge. It should read max hot or cold. Ground the wire to the block and ...

happening. The gauge or sender or wiring in defective or in need of repairs. No temp gage will go straight to hot like that. It moves based on temp rising. I would take the gauge out, test and replace

temp gauge and make sure the temp goes to the normal operating area and does not overheat the engine. if temp is ok and you have heat that is hot as normal then everything is ok.if no heat and temp is

...temp gauge is reading the same as the scan tool data that there are a couple of possibilities. Either the system has air in it from nepot being properly bled or the headgket is bad forcing air into ...

...temp gauge goes up to max hot the drops right back down in seconds. what could be the problem? I let it sit running in the yard an it doesn't do that temp gauge thing. I just replace radiator, ...

Temp gauge runs hot but car makes no heat...... HELP ... honda-tech.com/honda.../temp-gauge-runs-hot-but-car-makes-no-heat-h... Mar 28, 2010 - Temp gauge runs hot but car makes no heat. ... Honda-Tech

...Fan works but will only blow cold air. Temp control knob is turned to max heat. Engine temp gauge is reading normal operating temp. check coolant level, if ok change thermostat, it may be

...temp gauge on dash but the water tank itself when driving it sprays water all over engine, so he had look and told me that the spark plugs that i had on it were rubbish so he changed them and put new ...

and the temp up to max. The hot air will go directly out the windows and you will see the temp gauge drop back to about 80 degrees. I did this for a year until I figured out the relay needed replacing