...coil packs Code 345 means the cam sensor on bank two is not sending the correct signal to the engine computer. So no spark. If you have replaced the sensor, the problem could be the cam or the wiring ...
...Replaced cam and crank sensors, fuel pump, fuel pump relay, battery and ECU. Fuel getting to spark plugs, engine tumbling but there seems to be no electricity to coil packs Why would anyone replace ...
Question about Cars & Trucks
...COIL PACK STILL WILL NOT START If you have any dtc's, follow the flow chart. If no dtc's present, I would check your intake for any clogging. Can't tell you much without more information No spark ? ...
Question about Nissan Almera
replaced the cam shaft sensor, crank sensor and the coil pack. Iam also not getting spark to the coil pack. Any suggestions? Primary voltage to several systems, including the ignition coil, dark green
...COIL PACK REPLACED THE COIL PACK--CRANK SHAFT SENSOR--CAM SHAFT SENSOR&SPARK PLUGS-- BATTERY IS OK --APROX.50 PSI FUEL PRESSURE --CHECCKED FUSES&RELAYES--MOTOR TURNES OVER BUT CAR WILL NOT ...
Question about Cars & Trucks
...no spark, replaced coil pack, crank shaft senser, cam shaft sensor, icu, ecm, hot to coil pack,fuel pressure good Check the fuel pump emergency cut off just in case also may want to look at the
replaced the coil pack so whats left is ignition module, crank sensor, knock sensor, cam sensor, or the timing was not was not set properly when putting it back together. Any one of those would create
Question about Nissan Almera
...replaced the coil pack, crank sensor, cam sensor. some of the gauges go crazy when the car is on. the scanner will not read the codes, it says that it has no power . can you help me figure this ...
Question about Nissan Almera
...replaced crank and cam sensors what else could it be The ignition coil. Isn't the coil for 1 and 4 the same coil in the coil pack? One way to check is to swap that coil with another in the coil pack, ...
replaced all cam sensors crank sensor plugs all coil packs P0016 fault is poor crank/cam correlation. In other words the signals the ECU is receiving from the crank and/or cam sensors isn't making any
110 questions posted
Usually answered in minutes!
46 Questions
84 Questions
19 Questions
17 Questions
23 Questions