speaker and it still doesnt work Then the next step is to check the wiring to the radio with an OHM meter, if the continuity is ok (less than 3 ohms) then the radio is defective and you will need
...Check to insure you have properly matched the ohm ratings of the amp with your speakers. If you are running an amp rated for 4 ohms and due to running speakers with a total ohm load of less than the ...
Question about Mitsubishi Lancer
...check resistance and connection), or just have them put standard speakers in and possibly a new deck. It is hard to say without having the vehicle, but it is a wiring issue from the sounds of it. ...
...put in an aftermarket radio and it still has the same problem. You can test the speakers with an ohm meter[should read either 4 ohms or 8 ohm].if they tes good then check the wireing to the
...speaker had 2 negative and 2 postive terminals. the new speakers have one negative and one positive. Barely any sound comes thru the new spearks Check first to make sure impedance marked on speakers ...
speaker impedance can be higher without problems but it cant be lower ... if your speakers are the wrong impedance (too low) then the amp will heat up .. it will protect itself by shutting down before
...speaker goes out then the audio system will shut down, every on the radio appears to work just no sound, i would check all speakers out first, if all speakers test out good give this company a shout. ...
Pontiac sunfire 2000 stock radio keeps cutting out. Goes off and on for long periods of time. I checked the output leads from the radio to the speakers (8 leads for 4 speakers) and they all check out ...
...speaker, your will have to run a single wire probably to each speaker, but check what I said before. I will check mine tomorrow and let you know. I have the same car. I still have the original set
Question about Cars & Trucks
...speaker terminals. Now check left Channel at amplifier board if possible, and at speaker terminals. If no V unplug speaker wires if possible at board then test across board L+ and L- output pins. ...
22 questions posted
Usually answered in minutes!
997 Questions
654 Questions
213 Questions
209 Questions
136 Questions