1998 Mazda 323 F "volts cam sensor" Questions

...the sensor back to the car with the meter still attached set it to ac turn the engine over it should be between .2 and 2 volts repeat on the cam sensor. see were you go from there hope this ...

cam sensor signal drops to zero volts. You should be able to see the signal voiltage switch between 5V and 0V while turning the crank slowly. If so, the sensor is working properly. If the signal doesn

...signal at pcm, has 5 volt supply at cam sensor and ground at cam sensor. I thought it would start with the cam sensor unplugged, it would just have a long crank time. crankshaft sensor had same ...

...CAM SENSOR AND CRANK SENSOR!! hi thies car are know for crank sensors if you have a volt meter unplug the crank sensor and test the power to the orange wire with the ignition on the power should be 8 ...

...cam sensor checked for volt to the sensors ande coil pack all have there rated volts next i'm going to change the crank sensor to see if that is it ????????? yes def change crank sensor that controls ...

cam sensor with the key on. One is a 5 volt reference, 12v and PCM of computer signal. It seems that the short will give you something around 8.5 volt reference instead of 5. It has to be 5 volt + or

cam signal at pcm p0463 fuel sender volts too high P0340 Check for reference voltage going into cam sensor. If good voltage, most likely a bad sensor. But check condition of connector and wiring. High

volts. the engine code is po344,cam signal.where do I go from here? Both crank and cam sensors have a 8 volt reference I have found the wiring melted together where it cross over transmission shorting

...cam sensor, there is some short circut and no power goes to coils. When I supply power to sensor from batery, it start burning wires. the wires you are using may not be rated for 12 volts and a ...

...cam and crank sensors and even the pcm. all my fuses are good and asd relay seems ok. Im thinking anouther bad pcm. I have 12 volts going in and good grounds. Ant ideas? You likely already checked ...