2006 Ford Ranger 4.0 "leaking master slave cylinder" Questions

...master or slave cylinder may be bad. In some extreme cases I have seen the slave cylinder come loose from the transmission but that is rare. Check your reservoir for fluid, check the hose from the ...

Master Cyl. & the Clutch Slave Cylinder. I don't know if it's cold where you are but I've experienced a few Clutch slave cylinders that seemed to freeze, leak out & then continue to leak until

...master and slave cylinders for leakage. There is at the trans where the fluid line attaches. I can tell you it needs a slave and master cylinder, the trans has to come out to replace the slave. These ...

...MASTER CYLINDER ON 1986 FOR RANGER. CAN NOT GET CLUTCH TO BLEED, JUST ABOUT THE TIME I GET SOME CLUTCH, THE SLAVE SEAL STARTS LEAKING AT THE SEAL BEHIND THE TO BRG, NOT SURE WHY? The slave should not ...

master cylinder are bad,It does not have to be leaking to be bad,but it is one of the two.Rate please,thank you. The clutch is 'self bleeding' by slowly depressing and releasing the clutch pedal 15 or

...leaking and the trans will have to come out to replace, you should replace the clutch while its apart. if the fluid level is OK, then the master may be bad. probably lost the fluid from your clutch ...

...leaking. you may have a clutch master cylinder going bad,check your clutch resevoir beside of the brake booster and make sure its full if its low you may have a clutch slave cylinder leaking and that ...

...it disengages. It re-engages when lifting the clutch just a tiny bit. My thoughts are maybe its the master cylinder or slave cylinder. Yes you could have a bad slave cylinder or a leak on the ...

master. Have fluid to quick disconect at bell housing but can't get slave to take fluid even with Mity Vac. Any suggestions? Vehicle is 2001 Ford Ranger. mechanics bodge this one ,slacken bleed nipple

No clutch pedal pressure There is air in the line you will need to bleed the slave cylinder and find the leak so it doesnt happen again frequent cause is from master cylinder seal leaking.