2008 Ford Fusion 2.3 "stetched" Questions

Ad

when driving my 1999 vw passat its dies Check for possible fuel pump failure. Check fuel filter. Check air filter for obstruction in housing.Check timing belt for wear or stetching.

Ad

Question about Ford Fusion

1 Answer

I want to know how tight to tighten the bolts on the clutch pressure plate? Thankyou. The bolts should be 12 mm. The manufactures don't usually give tightening tourques for the clutch cover but I ...

Ad

Question about Ford Fusion

2 Answers

what dosea fusable link look like it looks like a battery cable or insulated wire. you will need a multi meter to check for continuity. Fuseable link are devices that protects a circuit from damage if

Question about Ford Fusion

2 Answers

tighten serpentine belt If this is an old belt I would recommend replacing it as they do stetch considerably over thier lifetime. There is a tensioner that needs to be pried back to accomplish this. ...

Question about Ford Fusion

1 Answer

Engine seems to be missing When idling..going up hills...sometimes on straight stetches...it seems to act like it's not getting gas for a split second or like the engine is missing...the private ...

Was getting around 18mpg, recently I pulled out in traffic and had to gun-it. A short time later I was going no-where. Had to pull over several times before realizing I could go, but only at a low ...

Question about Ford Fusion

2 Answers

...into a gear. I can then bring him the car, he said there's a wire or a cable that gets worn out or stetched too much. I can't find my owner's manual, so any asisstance is appreciated. ken in st

How do you checkout transmission fluid on a 05 grand am start the engine at idle speed and full it out the transmission guage must be in lower cross stetch line,,and when getting hot around 10 to 15 ...

Question about Ford Fusion

1 Answer

noisy belt Intermittent noise, specially when it starts, coming from the serpentine belt or pulley. How do I adjust the belt tension? It is spring loaded ,when worn belt slip and mini groove are too ...

Question about Ford Fusion

1 Answer

...away from the tensioners and tighten the belt as required. Once the belt is taut, but not stetched, simply tighten the two bolts up again and check that the belt has not lost its tension ...

Not finding what you are looking for?
2008 Ford Fusion 2.3 Logo

32 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...