2006 Ford Freestar Wagon "engine need removed replace head" Questions

...engine? The car has a bad lower end knock and I suspect a rod bearing is bad. I would like to replace the rod bearings to get a couple of more years out of the car. More than likely your crankshaft ...

...Sir, For replace head gasket you no need to remove engine you can replace gasket there only but you have to remove cylinder head and do head facing and then put it back with new gasket thanks. ...

choose ring installation tool to the correct size for your pistons. 5) re-install head of engine (replacing head gasket) Note that this procedure preserves the engine timing, so you need not reset it

...repair. With the right setup, it can be done with the engine in the vehicle....but it is easier to do with the engine removed (if you need to resurface the engine block you HAVE to remove the

engine does not need to be removed to replace the head gasket on your engine. More than likely it is an intake gasket that failed and showing the typical symptoms of a blown head gasket. If the intake

have to be removed You need to remove the intake and the pushrods and rocker arms from the head(s)-you should then be able to remove the lifters without removing the heads (third generation 3.1 engine

...engine, but what you need to check is the cylinder head due to you said it over heated, which will cause wrap head, Remove spark plugs crank engine and see if water come's out of spark plug hole's , ...

need to come off before I remove Engine Head. thanks. try to check, is it enough space to get the head bolt out without removing the cam? if ok, just follow your opinion. haynes maybe just told you to

...re-manufactured ones. You will need to replaced all the gaskets and cylinder head bolts. I also recommend to replace the engine thermostat when doing this engine work, and also do a complete tune

...need to remove the turbo or if i just remove nuts from manifold stud, is there enough wiggle room to remove head? i've already removed intake, front cam gears and all the rear stuff like dist., cam ...