2007 Ford Bantam 1.3i "hole punch wont work" Questions

hole that quirt on the windsheild an back glass try blowing out the line but does same thing even took the tank out an clean it get a pin and punch each side let it sit in warm water and then blow out

...the hole with a hammer and small punch and drive the pin in then you should be able to slide the cylinder out only other way I've done it is to drill the entire cylinder out which is not an easy ...

...punch (screwdriver will work if you have one you dont mind damaging). put the new stud in the hole and lightly tap into place (it wont fully seat untill you put the wheel back on and the lugnut pulls ...

...hole directly under the switch through the plastic column cover,and wiggle the switch and pull on it,it will come out...if no key then pull off the plastic cover,try to center punch perfectly on the ...

wont stay secure. My 1998 Jeep Cherokee's fender is not attached well, and I accidently took it fully off while trying to fix it. I discovered it would be really easy to reinstall, execpt for the fact

...hole punched in front tank (muddin )so I removed it and ran off back tank I observed fuel draining out unhooked return line next morning replaced valve (and tank) problem went away Disected old vlv ...

...wont start for nothing turn the key and it makes one tick and the lights go out help new job starting monday! lol plz :( and thank you in advance me and my mother think its fuel pump shot but we not ...

...HOLE IN FUEL TANK.START RAISING FLOOR JACK UNTIL SADDLE TOUCH GAS TANK JUST ENOUGH TO HOLD TANK IN PLACE.THEN YOU REMOVE FUEL PUMP SUPPORT STRAP BOLTS DROP FUEL TANK DISCONNECT FUEL SUPPLY AND RETURN ...

punch I have had this exact problem before and found only one solution other than replacing the caliper. On the opposite end of where the caliper pin goes in drill a small hole approx 3mm then take an

...may have bent a valve or punched a piston. Also found that the intake gasket was the wrong one Bolt holes lined up but some of the ports were either covered or not in the right places.Been working on ...