1980 Chevrolet Blazer 4.1 "transfer case lock front drive" Questions

...transfer case, & it still wont engage. I can hear the transfer case engage & I have vacum at the valve under the hood too, the cables pulls in but still wont engage the front differential. Make sure ...

...transfer case goes into gear but the front hubs seem like they dont lock in i was told it was a fuse or a vaccuum line but i have never heard of vaccuum lines affecting 4 wheel drive On the 1989 s10 ...

cable to ingage the front wheels my 4 wheel front will not ingage Probably not. These have two different units to lock and unlock 4wd. One locks the front diff, while the other locks the transfer case

...transfer case control module . The transfer case control module controls the transfer case encoder motor . Then there is the front drive axle clutch solenoid an front axle switch etc .. etc... etc... ...

...transfer case that gave a lot of problems. When the transfer case is shifted to a 4wd mode (high or low) this vacuum switch changes position and routes engine vacuum to the actuator located under the ...

...transfer case control module supplies a regulated 8 volt DC to the switch through circuit 431. The switch has circuit 1693 to return current to the automatic transfer case control module through a ...

transfer-case then to the engine. The switch is common to go bad and is located on the driver's side on top of the transfer case with three vacuum tubes coming out of it. Good luck and keep me posted,

...transfer case is permanently engaged but no 4 wheel drive... it first started with the service 4 wheel drive light flashing along with the electronic panel flashing. wile the lights on the electronic ...

...transfer case (shifter). It does not engage when I pull it into 4 high. I tried 4 low, and hear grinding as I was trying to get it out and put it into park. If the transmission seal is leaking could ...

...transfer case being engaged. To do this, all 4 wheels will need to be off the ground and the vehicle allowed to coast in gear to determine which it is. If you look at the front drive shaft and roll ...