Kyocera Finecam S3L Digital Camera "beach dust" Questions

...dust can be sucked in and jam the drive up. Sand from the beach is the worse problem. The most common fault is the camera has been dropped lens down from just about any height. If you're not handy it ...

beach dust dropped in beach. lense covered in mist and cannot turn on Cameras and beaches don't do well at all. The most important thing is to remove as much sand as possible without scratching ...

beach. Solution: use an air compressor. Blow air & dust through the hose first. Use clean air to blow out extended lens area. Open and close lens and blow out several times. Firmly jolt the camera

...beach or dust place for sure the said dust or sand goes inside of the lens unit and stuck up in lens gear that cause of your problem.try to send to service center and request for repair.if you have ...

...beach or place a lot of dust.possible the sand or dust goes indide of the lens gear and cause of stuck up and not fully open the lens.sometimes becuase of this the gear was damage or broken and you ...

...beach? It might have some dust or sand particles inside the lens. Have You changed the batteries? It can also be caused by poor battery.Please recharge battery or change new alkaline batteries. this ...

...beach and i fall and knocked my camera in the sand ive cleaned it out but its still showing camera error. the lense comes out but then shuts aagain its not that old and its on a fuji fine pixie j28 ...

...to take a camera to a beach, make sure it is in a sealed containment. The water vapour, any salt spray, sand, and or sand dust will certainly cause damage to even the most expensive cameras! Jerry

beach. - Take a thin strip of paper, and insert it in the cracks of the lens and circle around the lens and find any dust or anything. The paper slip should come out a bit dirty if that's the issue. -

...beach, use a cloth soaked in clean water and wrung well. ? If any dirt, dust, sand, or other foreign material adheres to the periphery of the lens cover after use, or the lens cover does not move ...