Xerox Phaser 8200 Laser Printer "unit failure" Questions

UNIT POLYGON MOTOR FAILURE Note If this failure reoccurs three times successively, an Engine NVRAM value is set preventing further printer use until the Clear Tech Rep Fault, Clear <09-380 ~ 09-383

Oki B6250 displaying error: ROS failure call service. ROS failure is the Laser Unit has gone bad and needs replaced.

unit 11 laser polygon motor failure I am in Alaska and can not get the machine to a repair person at a reasonable cost. I am getting a message that reads "unit 11 laser polygon motor failure" then it ...

...Unit Failure, U28 Error Code I got a U28 Cyan Imaging Unit error code on front panel of the Phaser 7300. I cleaned the contacts with alcohol and a Kimwipe, cleaned the LED's with the alcohol pad, no ...

Laser Unit Failure - Code U2 Change the LSU (laser unit)

...failure code 07 The most likely cause here is the laser unit, check all connections to the laser unit and cycle the power (turn the machine off and on) if error continues replace the laser unit. You ...

...unit motor failure. It is rare for a motor to fail so it may be one of your imaging units has seized. Remove the imaging units, one at a time, and check by turning the large white gear at the rear of ...

...toner failure, but the solution says to 1. remove & reinsert the cyan or magenta imaging units. 2. replace imaging units . check out the site to see if ...

...unit failure? Put in a new laser yellow cartridge and received the message that there was a laser unit failure. For some reason, your laser assembly has failed to power up properly. One reason could ...