is set correctly. If that doesnt help, you can run a test on the printhead to see if the reservoir can get up to temp. If that fails you may need to replace the printhead, which is very very expensive
Question about Xerox Phaser Office Equipment & Supplies
...8500n will not complete startup because of a 13,266.44 error. The service manual says that "the printhead reservoir heater took too long to reach its setpoint". In service mode when I turn on the ...
Question about Xerox Phaser Office Equipment & Supplies
...8500n will not complete startup because of a 13,266.44 error. The service manual says that "the printhead reservoir heater took too long to reach its setpoint". In service mode when I turn on the ...
...or the roller itself. but im not sure... can anyone helP 5200 is an abnormal temp. rise in the printhead. Not related to your other problems, but you need a new printhead. QY6-0063-000. Around ...
Question about Xerox Phaser Office Equipment & Supplies
...170XiIII Plus printer and we are having difficulty printing anything but black and white. We need some fields in gray scale. HELP! might need to adjust your printhead. Might have the temp set to
Question about Zebra Office Equipment & Supplies
...printhead. If so, lower the temp of the heat on print. Or you can speed up the print speed. I have seen this happen alot when the ambient temp is low, and the printer tries to make up for the ...
Question about Toshiba TEC Office Equipment & Supplies
printhead for the model of MLB and the correct firmware, but problem still exists. This excess temperature may be caused by a temperture detector. Ther are two detectors on a Toshiba Tec Printer. - On
Question about Xerox Phaser Office Equipment & Supplies
...printhead/ink replacement will fix the problem. I would contact them again and state that it was only a temp fix for your issue as it has happened again and ask if a possible unit exchange or ...
printhead and reinstalled. I get the same error message. Thanks. TW UO52 error is either a print head temp sensor error or faulty EEPROM data from the print head. You need to re-set the print head. If
Question about Xerox Phaser Office Equipment & Supplies
Printhead temp) is too high - normal is about 10 2. You have something stuck on one of the surfaces the ribbon is contacting, i.e. a piece of label. 3. Something is out of place that is contacting the
175 questions posted
Usually answered in minutes!
436 Questions
284 Questions
262 Questions
152 Questions
158 Questions