board in the machine. It is warming up properly , but once warm it is not pulsing the heat rod to maintain temperature. If you just walk away for a while, does the machine finally produce a fault code
...board on this unit. Also this does not happen each time before i had this issue i was troubleshooting a printing issue. the first page had pin strips above the image of transfer approximately 1/16" ...
Question about Toshiba Office Equipment & Supplies
...working? IF No • Check if the connector of the sensor is disconnected. • Check if any of the connectors on the LGC board is disconnected. • Check if the connector pins are disconnected and the ...
Question about Xerox Phaser Office Equipment & Supplies
...circuit board with it. If by circuit board you mean a piece of copper circuit track it is still quite possible to repair quite cheaply. If you mean a real part of the circuit board from the actual ...
working change heater, if not then IH board, and the last solution is to change the system board. If 1st time occur, u can just go to 08-400, reset the value to "0" then restart the machine. When
...board. YES Are the upper transport clutches (high/low speed) working? NO 1. Check if the connectors of the upper transport clutches (high/low speed) are disconnected. 2. Check if the connector CN362 ...
...circuited or open circuited. 5) Replace the registration sensor. 6) Replace the LGC board. If YES: Are the upper transport clutches (high/low speed) working? (Perform the output check: 03-439,
...circuit board is causing the problem that is why you wont really transmit and receive any data signal from the line. your analog circuit board needs fixing or replacing so that the digital circuit ...
...circuit board. 2. (nearly the same) some part within the circuit board is damaged. In both ways the circuit baord needs replacement. Unfurtunately the costs for this spare part is twice as high as a ...
...working properly? Check if the connector or joint connector of the revolver home position sensor is disconnected. 2) Check if the connector CN331 on the LGC board is disconnected. 3) Check if the ...
175 questions posted
Usually answered in minutes!
436 Questions
284 Questions
262 Questions
147 Questions
158 Questions