Question about Zebra Office Equipment & Supplies
I am trying to change a 300 dpi zebra 110XiIII+ printer to 200 dpi. I have the printhead. There is one screw in the center of the top of the printhead - where the toggles are. Unscrew, open printhead ...
Question about Epson Office Equipment & Supplies
soak for a couple of hours and repeat the process. Blot (don't rub) the water off the printhead and set it aside to air dry (you can accelerate this by using a hair dryer on the warm setting). One the
...Properties. Select the Paper/Quality tab. In the Print Quality area, choose the next higher quality setting. If the current setting is Draft, choose Normal. If the current setting is Normal, choose ...
.... Select the Paper/Quality tab. In the Print Quality area, choose the next higher quality setting. If the current setting is Draft, choose Normal. If the current setting is Normal, choose ...
Question about Zebra Office Equipment & Supplies
...Heater - toggle Printhead heaters to soften the ink. Manual separate the wiper and Printhead. Set them in their home positions. 5. Does the X-Axis Motor drive the Printhead to its center ...
Question about Zebra Office Equipment & Supplies
...cloth. Allow the printhead to airdry for a few hours (you can blowdry the printhead on thel low setting). Reinstall the printhead and cartridges. You may have to repeat this a couple of times if ...
Question about Zebra Office Equipment & Supplies
.... Select the Paper/Quality tab. In the Print Quality area, choose the next higher quality setting. If the current setting is Draft, choose Normal. If the current setting is Normal, choose ...
...the cartridges I have replaced the printhead with the photo printhead. I have done a wastetank reset I have cleaned the contacts on the printhead and the contacts in the carrier. The problem ...
...tape over the ink cartridge hole to keep the ink from drying out). Remove the printhead and set it in warm distilled water and let the printhead sit overnight. Remove the printhead from the ...
Set the printheads in the water in the same position they are set in the printer (vertical) You may need to place a wooden spoon of a block behind the printheads to keep the heads in position, as they
85 questions posted
Usually answered in minutes!
402 Questions
235 Questions
259 Questions
211 Questions
195 Questions