Question about Zebra Eltron Office Equipment & Supplies
green feed key down while turning the printer on; once the red light begins flashing, let go of the feed button. This will do three things: the printer will calibrate with the installed media, it will
Question about Zebra Eltron Office Equipment & Supplies
...green feed key. When the light flashed red, let go. At this point, the printer will calibrate and then print a configuration label. If this works as planned, you can eliminate the printer hardware as ...
red, but if I apply pressure to the lid it turns green. Is there something I can do to fix this? Here's the right way to fix the problem. Autosense Procedure, Configuration Label and Dump Mode: Models
Question about Zebra Office Equipment & Supplies
...it will callibrate, then print the page. However, when I try to print again, it will go back to flashing red. Any thoughts? When the light flashes red, press the green button once. What happens
...green/red light flashing i bought a used Zebra TLP 2844-z printer and when I turn it on the light is blinking green/red! Have no idea what does that mean! Please help! Check their website. It should ...
Question about Zebra Office Equipment & Supplies
...while printing Green light red I've a Zebra LP2824 printer , It gives me the Green-Red error .. And the manual guide told me that's a problem with flash programming .. What can I do to solve it
...green; my light stayed solid red. I've tried to send firmware few more times with the very same effect. Light is flashing yellow/red for a few minutes and than stays solid red. HELP!!!!!!!!!! I'm ...
green after releasing flashing red on power up so it will not enable line mode. How do you get around this or make it work properly? I don't believe that the 2844 can be put in line mode by using that
power button blinking If the Light is flashing Green it is waiting for you to press it. If flashing red the Main Board could be faulty.
green button and switch on power. - release after it starts red light flashing. - the printer will run a self test. - turn it off and then on again. - re-check the settings of the printing software. -
111 questions posted
Usually answered in minutes!
47 Questions
55 Questions
34 Questions
32 Questions
18 Questions