Question about Suzuki Van Van 125 Motorcycles
wrench for the front wheel spindle, where do I buy it and where can I get a manual for the 2004 model. Thanks Not sure about the size of the axle nut, but you can get service manuals on Amazon or eBay
...wrench works fine. Sometimes if someone has put too much Loctite on the nut, you may have to apply some heat to the nut. I've run into a few of these that the cheap Chinese air wrenches would not ...
Question about Harley Davidson Motorcycles
NUT ON THE FRONT AXLE OF A 2008 XL1200C SPORTSTER? I need to change the tire on my sportster I need to know what size the axle nut is to pick up a wrench on my way home. you must have a tape measure ?
Axle nut torque 2020 street bob In my day, we only used torque wrenches for cylinder heads. Axle nuts are just done tight with a standard socket bar. Rear axle nut torque for an 09 Dyna is 95-105 ft ...
nut and braze a short piece of 3/16 allen wrench in it. You want the allen wrench just long enough to go to the bottom of the broached hex hole in the bolts and leave the nut flush with the surface of
Question about Suzuki Van Van 125 Motorcycles
...nut with the wrench and screw in the allen in about three turns. Then pull clutch lever all the way in and leave it there. Take the allen wrench and turn out the screw while watching the clutch lever ...
Question about Suzuki Van Van 125 Motorcycles
...wrench to use. Any help? seriously? ok, it's japanese.. get a ruler and measure the nut from top to bottom to get the milimeter size and their you go... probably 14-16 (but who rents sockets?) buy a ...
...nut turn allen wrench clock wise on push rod until it just stops do not apply pressure you will bend push rod.then turn counter clock wise about half turn hold with allen wrench tighten lock nut . ...
Question about Harley Davidson Motorcycles
...my sportster and need to know what size of wrench to take the axle nut off. likely a 3/4 the large bikes use 15/16 inch. I just know what socket to grab but don't keep up with what size it is
...wrench or socket to avoid rounding off the nut. On the bottom of the right side fork tube you will find two bolts holding a cap on. After loosening the nut on the left side of the wheel, loosen the ...
6 questions posted
Usually answered in minutes!
329 Questions
228 Questions
165 Questions
158 Questions
169 Questions