Question about Bajaj Pulsar 180 Motorcycles
...slope on double load Two reasons...1) either you are riding with the pillion on a higher gear instead of the lower gears which are capable of pulling up. TIP: Always : prefer lower gears appropriate ...
...slope 2-up and clutch started slipping with smell of burning. I've looked inside transmission case and belt looks OK. Any ideas? even though the belt appeared to be okay it might not be. inspect the ...
...slope and keeping the throttle low for a while. Once this happens you must let the throttle go for 1-2 seconds and then open it again. 1)it happens progressively (it takes some seconds to ...
Question about Bajaj Pulsar 180 Motorcycles
slope. Since you have a fuel injected model you will need to prime your fuel injection after you run out of gas. Fill your tank with the gallon can, use the "off/run" switch with the key on to get the
Question about Bajaj Pulsar 180 Motorcycles
2. Jumper cables should have 8 or 6 gauge wire. 3. Only use a known good fully charged jumper battery. 4. When jumping from an automobile the engine "MUST" be off. 5. Connect the positive cable first.
Question about Bajaj Pulsar 180 Motorcycles
2. Jumper cables should have 8 or 6 gauge wire. 3. Only use a known good fully charged jumper battery. 4. When jumping from an automobile the engine "MUST" be off. 5. Connect the positive cable first.
Question about Bajaj Pulsar 180 Motorcycles
...FULLY INTO ITS GROOVE. Install the rings onto the piston. (Some OEM rings have a flat side and a sloped side be sure to match the piston you have removed) Notice that there are tiny notches in the ...
93 questions posted
Usually answered in minutes!
81 Questions
41 Questions
12 Questions