Question about Harley Davidson FLHR Road king Motorcycles
...remove pin, float and needle valve. clean needle, needle bore with carb cleaner. inspect needle seat and tip for any dirt/debris. install needle float as assembly, then check float adjustment ...
when the engine is running. Is the float stuck? either the float is stuck in the down position or the float needle cannot close properly due to debris in the float valve or a worn float valve assembly
Question about Harley Davidson FLHR Road king Motorcycles
...needle valve and it's seat. Either one will not allow the float/needle valve to shut off the flow of gas when the float bowl get's full. This should be your carb: ...
Question about Harley Davidson FLHR Road king Motorcycles
motorcycle/dirtbike/ttr225/starting problem. Is not getting gas to sparkplug.As long as i put gas in sparkplug hole motor fires until burns gas out. sounds like your pilot jet may be clogged, or your ...
Question about Harley Davidson FLHR Road king Motorcycles
...fuel is pouring from Carb it could be that the needle valve has stuck. This would allow fuel to just pour through the carb. Cleaning needle valve seat may work if that is the case Cheers ...
Question about Harley Davidson FLHR Road king Motorcycles
...needle valve. Replace the needle valve assembly if the tip is scoured or damaged. Lastly, make sure the floats are installed w/ the pins in the right position (towards the bottom of the float chamber ...
Question about Harley Davidson FLHR Road king Motorcycles
...my elan ski-doo 1980 250 mikuni carb floods out. Replaced all jets and still the same problem. Help The needle valve is stuck, you will have to get the carb. off and check the float and needle
...valve and **** it open to flush out the needle and seat. When the fuel runs clean, put the needle and float back on and open the fuel valve again. If the upside down carbs holds back the fuel- ...
...carb. The float needle may be stuck.you will need to remove carb and remove float chamber and clean or replace the needle valve.Check that the float is not faulty.ie that it has no fuel inside of
not getting fuel to carberator getting fuel past shutoff valve just not to carb Stuck float or neddle seat valve. remove the carb and clean make sure the float and needle seat are functioning.
24 questions posted
Usually answered in minutes!
180 Questions
151 Questions
96 Questions
15 Questions
11 Questions