2006 Honda Zoomer "spark plugging washer" Questions

...washer on motorcycles is not a good idea as the high pressure gets into all electrical connection the best thing to do is get a can of crc and spray pull the connectors apart and spray crc as well as ...

...spark plugs are fitted with a collapsible washer to ensure a gas-tight seal. The washer can be felt collapsing in the last approximately 60 - 90 degrees of turning and equally it can be easily felt ...

...spark plug, replace the plug sealing washer, or get a new plug, and torque properly. If the oil is on the porcelain, this can cause the spark to jump to ground and not give the combustion chamber a ...

...spark plugs there is a crush washer so do it up as you can comfortably then a 1/4 turn more.also the spark plug removing tool is to long so don't bother with this) Then move to the next plug Then ...

...washer worked fine last year and was winterized all start settings correct; had to use starter fluid to start this year and heavy blue smoke from exhaust for about 5 seconds and engine dies. Not a ...

it does not start most commonly with the Buell XB bikes the spark plugs foul out, very easily i might add. what you need to do is remove the air box lid (not to loose the vinyl washers and left side ...

washer or cover type thing over the spark plug and the socket wont grab. so i need to know how to get that off You have pulled off the plug lead ? You need to use a long reach socket, use the one that

...washer or hose pipe) and now im struggling to start it, it starts for a few seconds but is really ruff then cuts out,i cant think that its water as i have washed it many times this way. any ...

is part no for cx500 custom 1981 synthetic bung washer for spark plug drain hole The rubber oil gasket that keeps oil from pouring past the valve cover onto the spark plug is part number 12329-415-000

...spark across a gap racing plugs may have a different heat range or be anti fouling plugs as long as the reach ( length of thread to the sealing washer) and the thread pitch and diameter is the same ...