NetGear WGR614 Wireless Router "reconfigure 2wire" Questions

...reconfigure it. I gave all new DSL authentication and rest are set to default configuration. I setup the profile also on the computer and baloon shows 'excellent'. However, it's not getting connected ...

...contact them. If you entered and forgot, reset the device and reconfigure. Try the User Manual: http://support.2wire.com/view/765/2701HG_user_guide.pdf OR this:

...2wire power light is flashing and no internet connection. Try first to power off the router for 30 seconds to power cycle the unit and then check if that will correct the problem, if still the same ...

...on your 2wire by pressing the reset button of it for 15 seconds while power is ON and then after that power it OFF for 10 seconds and then reconfigure your unit and check if its working

...be the case. It has been several years since I set up the network. Toidikire I might advise you to reconfigure the speed stream maybe there are some hardware lock ups inside to the router, ...

...2wire wireless is always interupting but the desktop is fine try to change the wireless channel on the router and check if that works. If you face the same problem again then try to upgrade the ...

...check if line issue,....however if isp says not line issue then most probably it just needs to be reconfigured so i strongly recommend you could call your isp or att since there tech support for

...internet and misplaced keycode If you don't remember the password you will need to reset and reconfigure the router.  There should be a small button (or pin hole you will need a paper

I keep getting flashing red dsl light on my att wireless router with modem. also often get message- brodband hasn't connected. Its better once you reset the router and reconfigure

2wire 2700HG except for power but sometimes it has. I'm trying to reconfigure it but the problem is there's no ethernet connection. I can't also connect to the 192.168.0.1/192.168.1.1 or 192.168.1.254