Question about Microtek ScanMaker Office Equipment & Supplies
...adjustment. By 8 years using the lamp become darker and the light spectrum change in some wave lenghts the intensity. If you are using silverfast you should use a silverfast calibration target. Good ...
Question about Microtek ScanMaker Office Equipment & Supplies
Canon Scanner 5000F fails when adjusting lamp before scan. Using Canoscan program start to scan, Message given :"adjusting lamp" Then after peroid of time Message given: "Can not scan, Reason: Lamp ...
Question about Microtek ScanMaker Office Equipment & Supplies
...of the CCD amplifier is adjusted (sheet guide is read) during scanning.Probable causes are:- The lamp, optical system or white sheet guide is dirty- Defective lamp, heater, CCD, or inverter- ...
...adjustment of the CCD amplifier does not succeed at a READ command for the first document, or during scanning. Probable causes: - The lamp, the optical system or white sheet guide is dirty. - ...
...may not be set correctly. - The film adapter unit protective sheet may be put in place. the lamp may not be wamed up. (it takes a few minutes for adjusting lamp on low temperature) Scanner ...
...me what is wrong and how to approach fixing it? Thanks so much. Crysti Esper I think your flatbed lamp is damage if u replace or color it pure white ...
Question about Microtek ScanMaker Office Equipment & Supplies
...across the top of the image. It looks like the scanner is starting before the paper goes across the lamp. If you set Automatic brightness/Contrast this happens. Try manual setting. Adjust different ...
Question about Microtek ScanMaker Office Equipment & Supplies
...lamp gain on the rear page camera . Usually removing the camera & cleaning the optics will sort it out . The scanner will need a good service & shading adjustment as well . Only attempt this work if ...
Question about Microtek ScanMaker Office Equipment & Supplies
...There is a lamp shut-off time adjustment in ScanGear. Go into ScanGear's Advance Mode and click Preferences. One of the four tabs will have an option for Lamp Shut-Off time. Set it as
adjusting the lamp When i use my 4200f i always get the message "adjusting the lamp please wait" it sits there for 2-3 minutes and then cracks into life,is this correct? or can i do something about it
94 questions posted
Usually answered in minutes!
115 Questions
44 Questions
35 Questions
29 Questions
18 Questions