Quantum Fireball Lct15 (QML20000LC-A) 20 GB Hard Drive "jumper" Questions

How to set jumpers in an old quantum fireball Lct20 HD. The master mode needs to be "jumpered" Please look on top of your HD and u will see a table that show u the HD jumper setting (Master, Slave or ...

...do i configure this hard drive for a 'slave' ? You need to set the drive as a slave by moving the jumpers the the correct pins. You should see 4 sets of pins, for slave you put the jumper over the ...

what does the PK and RVSD on jumpers mean? Hello there, Jumper Parking (PK) Position The PK position is used as a holding place for the jumper for a slave drive in systems that do not support Cable ...

...a PC. You want the drive to be the slave drive, and you know what that you must change the current jumper settings. The four jumpers on the drive are labeled DS, CS, PK, and Rsvd. The description of ...

old maxtor harddrive need to know jumper cofiguration Most Maxtor Drives have jumper setting so that if "Jumper 50" is set; the two pins farthest from the power jack, is Master Drive. No pin jumper ...

...a boot up message stating "primary Hard drive 0 not found". In the Bios, it is listed as "unknown". Jumpers set on CS, but tried Master too...the maddening thing is that when I slave this HD to ...

need a jumper diagram i need to know where the jumper is to be put on for master and slave quantum 30gig This is usually marked on the drive as a label and moulded onto the end cap. If this does not ...

...to farmat it frist how do i add the 20 G.B. quantum fireball HD to my coputer and how do i set the jumper If I recall right this HDD is a PATA (IDE) type. As for the Jumpers please check the ...

...20 hard disk to my computer. When turned on, it cannot detect the hard disk. Tried several position jumper configuration but still not detected. Please advise on how to set position of jumper found ...

wanting to use as slave hard drive i need to know what jumper pins i need to cover or pull out hi ronrayhall, I installed a maxtor hard drive, and they are shipped with a default of cable select. If ...