Dual TOA IP-600D Channel, 400W Power Amplifier, Stereo Amplifier with 400/600 Watts per Channel (IP6... Car Audio Amplifier "400 watt amp turning" Questions

400 hooked to 2 150w crate speakers. you can here the audio but its weak with the amp turned all the way up. i hooked a seven watt speaker to it bridged turned it all the way up and it pushed it good.

watt magnet 500g (17.6)oz impedence 4 ohm kfc-w300s speakers It's not bad, but at 400 watts, it's a bit underpowered It'll be plenty loud, but the amp will distort before the speakers do, particularly

...400 Watts) being over my speakers max (300 Watts)? I want to get the most power out of my amp for these speakers. Thanks for any help you guys can give. Hi Trim God, I do not reccommend that you push ...

...400 Watts Nominal what size amp should I be using? The speaker info is telling you that a 400watt input is nominal or stable. and handle anything that can Peak up to 1200watt , the speaker can handle ...

...amp for my sub given that my subwoofer is rated at 400 W RMS? Can this amplifier handle a pioneer TS-W307D4 or TS-308D4 pioneer subwoofer (12 inch double voice coil 400 W rms) or should i go for a ...

my amp doesn't want to turn on, it's doesn't smell burnt, and the fuse is still good... What could it be? It's the remote wire it is what activates the on off feature ..... You can test this option by

...400 watt amp when loaded to it's lowest rated load. If you have one speaker per channel (the only safe load if you have single 4 ohm coil speakers), you're only getting 165 watts/speaker. It's ...

...400 watt rms. Hmmmm. Anyway, just bridge the amp (1x 380) nd keep the gain up enough to stay clean. Watch the sub and turn up gain until it starts to distort, then back it down a hair. Do this with ...

protect led flashing with hit of bass protect led is flashing on my blaupunkt gta 260 amp. when hard bass hits it flashes Try a bigger amp. This one wants to be turned down. But seriously the protect ...

...400 watt rms alpine type R this problem happened with another amp i had so iam kinda thinking it could be a wiring problem... The ohm load may be too low. What make/model amp is it? Your gunning your ...