Craftsman 16" Electric Chainsaw Chain Saw 3.5 Hp "wont oil" Questions

...wont oil the chain and bar it is a poulan 2000 woodsman the poulan chainsaw wont oil it is a 2000 woodsman no oil going to bar and chain did you check the oil hole on the bar to see if it clogged? ...

...wont oil i have a poulan pp4620avl, bar is not getting oil,plse hlp Thks ok the port the oil flos thru is most likely clogged. drain oil pull bar cover off put an airhose in the oil tank and cover ...

...wont pull start I pulled cord a couple times (wasn't to easy) and on the third pull I couldn't budge it. Some saws with autotmatic oiling will leak bar oil into the cylinder and cause this. Pull out ...

...wont start What is the ratio of the oil/gas mix? Sounds like it is not getting sufficient lubrication. Add 1/2 oz (about 1/2 shot glass) of 2-cycle oil to the gas tank and try again...... Check to be ...

...oil was quite low.I tried pulling it again,and it wont even pull at all,tried the electric start and wont turn over,,just wondering if its done.Should I even get it looked @ or am I wasting time and ...

...wont stay running I have changed the fuel lines and put in a new spark plug. It will start and idle but bog down whenever I give it gas. Then it Won't start. At all for a while. I cleaned the ...

...oil level sensor float wont work and causes a shut down to protect the generator engine from damage try draining oil and refilling with 20w/50 oil cheers pauly46 Try letting it run without anything ...

the chain oiler wont work. i cleaned out the tank still wont oil ? check the oil pump, maybe blocked or worm gear problem

...oil feeder wont oil chain 38cc tree hawk talon oil feeder wont oil chain 38cc tree hawk kind regards anthony hi first check the oil filter from the oil tank,the oil hose,remove the oil pump and check ...

...wont start, have spark, fuel 80ml oil to 5lts fuel, seems to flood too easily. Wont even start with easy start spray. Have no idea what position the adjustment screws should be adjusted too leave the ...