...Stereo Power (RMS): 250W X 2 4 Ohm Mono Power (RMS): 850W X 1 2 Ohm Stereo Power (RMS): 450W X 2 Signal-to-noise ratio: 100 dB Frequency Response: 5 Hz - 50 KHz Total Harmonic Distortion: 0.05% Input ...
...the watts is on amp 123W x 4 Channel Max. Power Output at 2 Stereo 70W x 4 Channel 0.1% THD at 2 Stereo @13.8V (RMS Continuous Power) 50W x 4 Channel 0.1% THD at 4 Stereo @13.8V (RMS Continuous
...power to stereo I installed an amp and subwoofer myself. I had the stereo head outside of the harness and hooked it to the car amp and everything was running fine. however, when i put the stereo back ...
...stereo its self. there are two power wires on the back of the stereo, one that is permanent live for the stereo's memory, and one that is semi live that dies when the ignition is turned off. the semi ...
stereo) OR a Line-Out converter AND RCA cables. - The power lead that connects to your "REMOTE" line on your stereo (long enough to reach from amp to stereo - usually blue) - A good ground wire ( long
...Power) @ 2 ohm stereo 0.008% @ 4 ohm stereo 0.004% @ 4 ohm bridged 0.008% Signal to Noise (A-weighted 4 ohm) 105dB Freq. Response @ 4ohm stereo 20Hz-20kHz +0,-0.7 Crosstalk 4ohm -70dB Slew ...
...stereo/bridgeable amp 350 watts max power model #kac~6295 it just dnt sound rite any sugestions? make sure you run your power and ground wires opposite of the rca/speaker wires. you tend to pick up ...
...power my car stereo in my house? What do I need? You would do best with a 12volt inverter. It will bring the house voltage down to the necessary 12 volts for your car stereo. Best of Luck. This video ...
stereo has a wire that sends out a power signal when it is turned on you could try that for the blue wire. Just make sure you have the negative battery cable on the car disconnected so you don't short
73 questions posted
Usually answered in minutes!
202 Questions
203 Questions
165 Questions
142 Questions
149 Questions
