Kenwood VR-307 Receiver "protect amp" Questions

PROTECTED MODE CAN YOU HELP ME UN PROTECTED Amp output is damaged and needs repaired. Protect mode cannot be deactivated. When amp is repaired and operating normally protect mode will not be displayed

...amp protect mode Onkyo receiver TX-SR600? My receiver is in the Amp protect mode. How do I reset my amp / receiver from protect mode ? if your receiver is in protect mode then that is one of two ...

amp goes to protect mode The most common cause of this is that one of the speaker voice coils is shorted or the wiring to one of the speakers is shorted. Disconnect the speakers one at a time and

from the amp to protect them from damage should the power amp stage experience a catastrophic failure. Unless you are a trained technician, you should have the unit repaired before major damage occurs

i have a yamaha m65 power amp. the amp lights up but the red protection light stays on. no sound. the power amps are blown and need replacing, the protect circut is stopping any further dammage

..."protected" when i turn it on and goes into standby there is an internal shorting inside the amp that puts the amp in protect mode also check if the amp comes on after disconnecting the ...

How do I turn off protection on the amp? I cannot turn anything up loud before the amp "overloads" and the switches off for protection What is the make and model of the amp?

fisher rs-851 in standby? If by "standby" you mean the amp is trying to power up, check for speaker protection issues. Speaker wires and/or speaker issues may be causing the speaker protection mode to

...amp, if the protect is no longer displayed when the unit is turned back on, check the connections on the speakers. If you do not visually see a short on the speaker wire connection, turn off the unit ...

...protect the output transistors from, shorted speaker wires, shorted speakers, too low speaker impediance,make sure the amp is well ventilated. turn the amp off for 1 to 2 hours to allow thermal reset ...