Panasonic CT-27SC13 27" TV "board dry solder" Questions

...board carefully for any dry soldering of component leads. (dry soldering means loose contact or bad contact of component lead in the soldering side of the base board can happen after years of use.). ...

...dry joint ( a solder point on the circuit board has come loose) the only way to fix this is to have the board taken out turned upside down and find were the dry joint is and re - solder it. if your ...

the screen just went red and black. How to adjust it? hi, just check the base board on the picture tube neck for any dry soldering. if found any dry soldering then re-solder that points. ok

DRY SOLDER JOINT on the mother board. The fault can be found our if you can use a good light and observation lens , use a good soldering station to redo the solder on drive IC's and power circuits

dry joints around the board especially on the power supply section.Cold solder is hard to spot, it is necessary that your working area have sufficient source of light or you may use a table lamp. Hope

dry soldering in the power supply sections or in the processor sections in the main board. It will be good to remove the power plug and check all the leads, the connectors and the PCB for signs of dry

board holding the DFS module. This will eliminate the 'DRY JOINTS' that are causing your problems ... tried it myself on a few TV's works a treat ... THE DFS solder connections suffer from dry joints

...flickering on and off re soldered component parts at chroma board which cold soldered or dry joints.the chroma or video board is attached at the neck of picture tube.just let me know if it

...fix it? It would be dry solder joints on the circuit board. Boards will need to be re flowed with solder. You will need to be skilled with a soldering iron otherwise will need to be done in

...dry soldering can appear on the base board at the pins of base socket (you can see socket which is attached to the picture tube neck and its pins ...