Panasonic PT-51HX41 51" Rear Projection Television "blue square tv" Questions

...blue square is quite off on left side of the TV. I can not move blue square to the left side only. Convergence amp ICs need replacing and quite possibly the resisors that power the IC as they usually ...

...blue lines are more or less loopy,Curved not square or straight horizonto or vertical. do you know what could be the problem? How can I fix it? The Samsung has bad convergence IC's most likly. This ...

...TV. The red images is curved up at the top sides and curved down at the bottom sides. I have tried using the convergence to adjust the red and blue colors. The red cannot be adjusted on the sides. I ...

blue and red semi-circular areas at the bottom of the picture. I've posted this solution several times but here goes. Try setting up the convergence through the menu by accessing the convergence setup

...square in upper left and returns to menu rather than cycle through red, green and blue. can I do anything about this or is the convergence board dead? Yes,replaced the board or buy a convergence kit ...

...and blue the light should have square edges take the back off look in the crt"s if the light is not square.then the electronic control has to be repaired by a tv repair shop prob. a bad ...

...blue square in the the center of the screen (it is computer "problem blue". After a few minutes, a "press any key" message comes up. I use the cable remote & it disappears. I've called the cable ...

...blue flashing squares ok , showing on all sides, but red flashing square top and bottom sides ok, but not showing on right side of screen and only showing on left side of screen about 3 to 4 inches ...

...SQUARE Hey Is there a way to MANUALLY move the BLUE light to converge it with the other 2? Only my BLUE light can't allign,,,,can't see why I can't move it manually looking into a mirror. ( When I ...

...blue tubes to converge on the green image. Can the green tube be aligned to give a nice squared, in focus image? Ur tv convergence are dead.U know how to solders?Must replaced the 2 STK convergence ...