Panasonic PT-53WX53 53" Rear Projection HDTV-Ready Television "remove control board hitachi" Questions

...remove front grill assy to front of the internal pc boards.on your left side ther is a blue rest button mounted on the convergence board this is the eprom rest ,unless yuo know and have the service ...

...control to make the adjustments. Replace Both of your STK ICs they are big black ICs will have part number on them STK392-110 or 150s Call MATs Electronics for parts 1-800-628-1118 There is no code ...

...Remove the Cap, clean the contacts with thin fine sand paper, blow out, reseal hope it helps. If the set is working on the video inputs, then it has be be an issue with the input source or the tuner ...

remove the board in the set and send it out to someone like PTS Electronics who repairs/rebuilds all kinds of boards. What they did was to cram a lot of parts on a fairly small board (from the back of

...if not tv has corrupted data (try unplugging tv for 1 minute and then retry) ifstill bad tv has bad control board or logic problem, either one will require tv tech to fix, hope this helps, ...

...control board but it could also have a problem with the flex cables that connect from 6871QRH037A to the plasma panel. Keep the ventilation openings clear. Do not put TV near appliances that create ...

...remove the speaker grill cover and the small access panel, then depending on the chassis you will see a small square with 6 dials on it 3 on top and 3 on the bottom it will have screen stamped on it. ...

...remove the front keyboard and unsolder that 2 pin switch---remote will with the board back still turn set on.If it works that way either just use the remote or search for the keyboard and replace if ...

...control the tv.. ie. turn it off Likely a communication error--lock up means micro is confused and hence only way to turn set off is to remove power which allows the micro to reset itself.Whatever is ...

...control board, there are bad tact switches on the control board,or the CRTs are leaking fluid onto the printed circuit boards Good Luck If your PS waveform drops out it could be your 130v regulator ...