...set to PCM or 48k/96k datastream to work correctly. If this doesn't help, you may have a compatibility issue with your HDMI device. Usually it is the fault of the player/video receiver and rarely the ...
...HDMI inputs #2,3, & 4 no longer work. I have my Direct TV hooked up to the #1 & my Playstation 3 hooked up to the #2. The # 1 still works, but the others don't. Idid try all of them out also. ...
Question about Panasonic Televison & Video
...HDMI and component ports. After the replacement, all the ports work, but the screen image only fills 3/4 of the screen and starts from the left bezel side and stops 3/4 of the way to the right. The ...
...hdmi or component cable is used you need to change your input on the tv with your remote to the matching input you wired it to. The uverse stb (set top box) changes the actual channels once you have ...
Question about Televison & Video
...HDMI input is working on my set. Owing to Mother Nature's unbridled fury during a recent lightning storm, and despite the fact that my TV was well protected by an appropriately rated surge ...
Question about Sony S Televison & Video
...set top "cable box" tuner, you would connect the coax cable from the UHF / VHF antenna or cable into the ANT cable connector on the rear of the TV as shown on page 8 & 9 in the manual. You would ...
Question about Sony S Televison & Video
...light) blinking 3 (three) times on both models. no switching on. please help HI if the red light blinks 3 times then the main board is defective so please replace main board & set will become ...
set top box or converter output on channel 3 or channel 4. If you have HD cable service however, you probably watch on one of the A/V or HDMI inputs (Video 1, Video 2, etc.). Simply press the Video or
Question about Sony S Televison & Video
...3, 5 (etc.). We noticed on that when Input 1 & Input 2 are highlighted at the same time, we get this failure. When only Input 1 is highlighted, the TV works just fine. Please help as I am ...
...set it up: 1. Install a 2-way splitter on the input cable 2. Connect output 1 from the splitter to the Humax receiver 3. Connect the Humax receiver to the TV with an HDMI cable 4. Connect output 2 ...
16 questions posted
Usually answered in minutes!
51 Questions
11 Questions
0 Questions
5 Questions