...Lamp Driver with a 1468798-16. The TV comes on, and I get a picture for about 30 seconds and then the picture/lamp goes out while the green light blinks. Then the picture/lamp comes back for about 30 ...
...lamp driver (ballast) problem. remove lamp and check the connections of the lamp driver and the lamp itself.Connections may look burned.if they do replace that part (lamp or lamp driver). If the lamp ...
...Lamp Driver Problem? Sony LCD TV? My LCD TV has been getting progressively worse - instead of turning on - it will give off a buzzing sound and go to standby mode. (without turning lamp etc on) For ...
Question about Sony Televison & Video
...lamp driver or the lamp? If it does need the lamp driver, how do I replace it? Is there a manual? Any suggestions on where to purchase the parts? Thanks! 5 times blink code means Lamp Driver error ...
...lamp driver problem on a sony grand wega 50" tv? Could be lamp, driver bd., or both. Probably $250 for driver replacement. THE LAMP DRIVER COST IS ABOUT $125 plus labor marbe $350 , avery tv shop has ...
Question about Sony Televison & Video
...lamp driver(ballast) are ok or they look bit burned.Also the lamp should always be replaced first especially if is two years old or more. Check to see how many times the error indicator flashes.If it ...
Lamp enable line at connector J14 pin 6 on the Engine Driver PCB switches to 5 volts after turn on and does go to 0-volts (low) after 5 seconds, 12 and 5 volt supplies are good. Suspect the Lamp Power
lamp driver What does a lamp driver board look like and WHERE is it located in the TV? Is it part of the housing cage around the BULB? I'm trying to order a lamp driver board and cannot find specific ...
Lamp enable line at connector J14 pin 6 on the Engine Driver PCB switches to 5 volts after turn on and does go to 0-volts (low) after 5 seconds, 12 and 5 volt supplies are good. Suspect the Lamp Power
...lamp driver. Total bulb hours used 5698. Original factory installed bulb, never been replaced. Sony techs say it needs a new lamp or the power supply box needs to be replaced. I am also getting ...
773 questions posted
Usually answered in minutes!
1,430 Questions
874 Questions
716 Questions
601 Questions
479 Questions