Question about Radio Shack Radio Communications
Have a pro-97 with power probems. I pluged an external power into the unit with battery pack installed. Now have no battery power. What can I do? first of all I have this radio, and i bought the power
bc340crs has power but will not turn on I have the BC340CRS. It is getting power because the clocks and light works but when I go to turn it on it does not work. Sounds like its not getting enough ...
...electronics engineer ...if it is good(not damaged) but you are asking how to increase its rf output power then an electronics engineer might design a custom electronic circuit with RF amplifier that ...
Has power but will not turn on. It has power because the light and clock works but it will not turn on. Check power source to make sure it is correct voltage/amps
uniden bc 760 xlt does not power up no 8 volt 5 volt is high 5.6 no display and a power hum from speaker try another power supply??
...the lights have been diming when I transmit. Yesterday unfortunately as I was adjusting the rf power knob the display( frequency counter) shut off, I turned the radio off then back on the ...
Question about Uniden Radio Communications
...somewhere inside of the unit There's a fuse in line with the DC (vehicle) cord, but none for AC power operation. Check the power supply with a voltmeter to be sure it's outputting power to the ...
Question about Kenwood Radio Communications
What could cause Transceiver to shut when power output is increased over 40 watts? My first guess would be that you have a bad/poor antenna,coax, causing high reflected power, next would your power ...
Question about Radio Shack Radio Communications
...settings. You can, however, restore the 150 pre-programmed frequencies after a RESET. To RESET: - Power the scanner OFF. - Hold down the 2, 9, and PSE keys and power the scanner ON. - CLEAr appears ...
192 questions posted
Usually answered in minutes!
247 Questions
183 Questions
153 Questions
141 Questions
106 Questions