Question about Mitsubishi Televison & Video
...loss of power, will not turn on Great television, lots of years of good images until last few weeks with an occasional loss of picture for 2 to 5 seconds. After two weeks of about 5 occurances the ...
...power tv loss all power while watching, fuse ok. power light on front of tv doesn't come on. There is a install kit 483531057673 for this model when the set is dead. The kit will contain 7404 and the ...
power LED on the front panel will blink a two digit sequence. This will be one set of blinks a short pause then another set of blinks, this will repeat 5 times. 1 - 2 = no error detected 2 - 1 = X-ray
power down by itself. Soemtimes it will stay on for an hour, but more than not I have to turn it back on every 10 to 15 minutes 1. In this case its better not to use in order avoid damage on the board
...awhile. Sometimes, it turns itself back on w/o a slap. It's a good TV and want to keep it. How repair intermittent power loss? you need to check all the cracked solder joints and resolder ...
loss of power was do to a blown fuse. could not access it through the small opening near where the power cord went in at the back of set.. carefully took the back of just far enough to access the fuse
loss power, and when i try to turn it on again, its not working, there is no red light when im trying to turn it on,, There is problem with the internal power supply of the TV set,if you are technical
...LIMITERS 1 OHM OR SOLIDER IN FUSES FOR + & - SUPPLY THEY FEED THE CONVERGENCE IC'S YOU NEED TO VERIFY YOU HAVE YOUR POWER SOURCE TO THESE. ALSO A LOSS OF VERTICAL DEFLECTION WILL CAUSE
loss power so I took back off and the 5 amp fuse was blown. replaced with new fuse but still has no power. what do I look for next? If you wish to get some details; check the site linked here. Pull up
97 questions posted
Usually answered in minutes!
1,061 Questions
920 Questions
867 Questions
724 Questions
662 Questions