Philips 60PP9202 60" Rear Projection HDTV-Ready Television "1516" Questions

...flyback. Try the convergence chip test first. Note: On some Philips sets you can just unplug cable "1516" instead of removing the chips. For instructions on how to find/remove cable 1516 visit the ...

...middle board is the LSB, and the board on the right is the power supply board. Try yanking cable 1516 that connects the SSB to the LSB. Its a small white ribbon cable. Does the set turn on now? If ...

...is shorting. Remove the back cover. Look into the far north,there is a jumper jacket{location #1516] I believe. Lift this jacket up and then plug in the TV and power up. Do the tubes light up ...

flyback. Try the convergence chip test first. Note: On some Philips sets you can just unplug cable "1516" instead of removing the chips

...problem for this model. Pull the back cover off and look to the north and look for a jumper jack [1516 i beleive] and pull this off. [TV unplugged of course] Now plug in the tv and power up...If

...will be white and wide. About three inches long and a inch and half wide. Look for location number 1516. Remove one end of this. Now plug the TV in and turn it on.See if the screen lights up, stays ...

...flyback. Try the convergence chip test first. Note: On some Philips sets you can just unplug cable "1516" instead of removing the chips. For instructions on how to find/remove cable 1516 visit the ...

...flyback. Try the convergence chip test first. Note: On some Philips sets you can just unplug cable "1516" instead of removing the chips. For instructions on how to find/remove cable 1516 visit the ...

...can find the correct board with the problem. A good place to start is to disconnect the jumper jack 1516 [TV unplugged first]. Now plug in the TV, and power the TV on. If the tubes light up and shut ...

...ic's are located on large signal board. to verify error is correct would recommend disconnecting 1516 6 pin connector on lsb to msb as sometimes that board causes shutdown issues and if no change ...