Sanyo DS31520 31" TV "reset again" Questions

reset the tv must be switched off and on again. after a while this happens every 3 to 5 min. Everytime the tv must be switched off and on again. This could be a component failure or a bad solder joint

tv just turned off and now it will not turn on, just a small clicking sound also reset all settings to factory defaults.press menu button and reset. try a hard reset unplug for 30mins and try again.

...thing so there is no "reset" button. If you think you have some chips in there you can always try pulling plug while set is on, holding power button for a minute, replugging in and turning on

...again. To reset and clear the v-chip settings. To do this, put it in standby mode, then press the POWER and ACTION buttons at the same time and then turn the power off. The set should reset to the ...

...RESET button. Do not attempt to turn on the TV again during this period. Wait for the flashing to stop and the light to turn off, before attempting to turn the TV on. While the TV is powered on, the ...

.other suggestions??? just unplug tv 5 minutes. and plug it again. power on again. if not reset tv. If you can hear the TV start to power up, and shuts off you most likely have a high voltage problem

...That beeping sound is notice that something blew. The reset is on the circuit board inside but if you reset it before fixing the problem then it will likely just flip again - safety/annoyance

...locate either. There is no reset button per say, try unplugging the tv for a few minutes and plug it back in again and see if it will reset. If not then you may have a component failure in your

...Enter the code you want to set and press enter. Press RESET button Reenter the same code again and press ENTER Enter the same password again and this should let you in to the settings Good

again. Is there a reset button to reset or is my TV fried? kindly respond or suggest ideas to prevent this ever again. I had a surge protector connected but my TV was the only unit affected- cable box