Question about Sharp Aquos Televison & Video
...TV, then the sound stopped on this channel. I found the same, no sound problem, on three other channels (12,48,51). While on all the other channels the sound is fine. I've hooked the TV to another ...
Question about Sharp Aquos Televison & Video
...tv channels do not have sound. It is NOT a Varous tv channels do not have sound. It is NOT a cable problem and reboot- run "setup" does not work. this is a direct cable connect - a basic digital set ...
Question about Sharp Aquos Televison & Video
...TV tunes in all of the other channels including all the QAM local HDTV channels just fine. Sounds like the signal is probably too strong. The TV is not the problem. I finally got Sharp to repair the ...
Question about Sharp Aquos Televison & Video
...channels as soon as I get to channel 7.1 the TV gets "stuck", it won't advance past the channel or go back to previous channel. Up until two days ago 7.1 did not present any problems at all. Not sure ...
Question about Sharp Aquos Televison & Video
...tv. the channel stays on 2.1 and not move up or down. Any sound advise will help! Well the advise I have for you is the TV is not connected to a good antenna or something is fouled with the sgnal or ...
TV, and they work for channels 2 through 13. What's my best fix? using the magnovox remote, reprogram the vcr's channels. set it up to use cable not air. when the vcr was unlugged it lost it's channel
...stereo and NOT SAP. I had the same problem on a new LCD TV, with 2 channels not having sound, the rest were fine. I ran a channel scan to have it detect the local channels, and it solved the
...sound on following channels - 5,6,8,10,12,13,23,24,25,28,34,35,48, video OK. Please advice. Thanks. Sasha. I cannot say pariculary for this model, but on some models of TV sets, if the channels are ...
Question about Sharp Aquos Televison & Video
...TV seemed in "demo" mode. Picture was showing at times, sound was good, but stuck on one channel, and impossible to change anything, either on TV itself or with remote. go into programming mode and ...
9 questions posted
Usually answered in minutes!
878 Questions
339 Questions
295 Questions
241 Questions
202 Questions