...module on the right via CN5702 connector only. - Confirm control voltage present at power on switch terminal that connects to the main processor module. No schematic drawings. Can you please assist ? ...
I have 3 black stripes on my Zenith 42 I have 3 black stripes (one of them has a couple of colored lines in it) on my Zenith P42W34 42'' plasma tv. I had the power on and I changed the cable ...
...pressurized screen. this is very costly and, it can only be fitted at the manufactures location or terminal. contact LG(Zenith) for this
...hour (to dissipate power inside); press the RESET button at the rear of the unit below the RS232C terminal; press the SYSTEM RESET in the same area.Hope this be of initial help/idea. Pls post back ...
...it on.I found this solution.."If this happens right away or after only a few seconds, there is a 3 terminal voltage regulator with 7805 in its part number that may have a low output voltage rather ...
Question about Hitachi Televison & Video
...experience with wires etc. Go to the source of your cable signal connector . Open it and clean the terminals with emery paper , sand the end of the cable shiny clean from corrosion , get a new
Question about Pioneer Televison & Video
my pioneer pdp-4270xd loses the channels when I turn it off. which board do I need to change to fix this? Fault at its main digital board. Short circuited component/s at it. Contact any service ...
291 questions posted
Usually answered in minutes!
878 Questions
339 Questions
295 Questions
241 Questions
163 Questions