...need toput power amplifiers that drive the speakers and then connect the board to the power amps. Use BALANCED interconnects for this and power the board from the same receptacle or surce as the
outputs of the Mackie into the stereo "returns" on the EV. Use TRS interconnect cables as these are balanced lines
...board puts out line-level signals and that should drive any connected amp or powered speaker to the full capability. Make sure you are using BALANCED interconnect lines either XLR or TRS cables. Use ...
...power on teh board the speakers start clicking - at first it was a very loud popping sound but now it is just a semi loud clicking but it is constant Make sure you use BALANCED interconnection cables ...
...to drive speakers from the aux outputs are you? These are LINE outputs that should be using TRS balanced lines to either powered speakers or amplifiers. Often these are used for monitors. The ...
board with, but I would use an oscilloscope to look at the outputs to see if any of the regulators are drooping. Clicking is a broad term... if it is a relay, it PROBABLY is for speaker protection and
...board could have been fried. Word of WARNING: Power ALL interconnected parts of your system from the SAME receptacle or source. Powering say a mixer from a receptacle at the back of the room and ...
...board; hence, the microphone in the latter situation. short answer- "yes, but..." This amplifier isn't powerful enough to run a cabinet but you could put it through another instrument amplifier ...
...power my upper passive cabs. I'm looking to add a York powered sub to the system to add the extra punch. Which out-puts should I be using at this point to control the sub sound levels? ...
...board when there is stuff plugged into it. Thanks and have a great day. Mark. Make sure you are using balanced lines, especially to the power amps. ALSO make sure ALL interconnected equipment is ...
2 questions posted
Usually answered in minutes!
124 Questions
35 Questions
24 Questions
14 Questions