Question about Emerson Televison & Video
...tape... Hi. your VCR is experiencing a major mechanism fault within the head assembly. the head is unable to read the tape. in this case, you will need to replace the main head assembly in this
...tape carriage assembly (this is the assembly which loads and unloads the tape). There will be 2 or 4 screws which hold this assembly in place. It is possible however, these screws are "covered up" by ...
...assembly, but check to make sure the flex cable going to the drum is properly seated. Sony DSR-45 Error Code C3140 this will even happen if ur Upper cassette compartment is not properly loading. Coz ...
...assembly that runs the tape and reels it in on eject, the drive belt will probably need replacing that is attached to the assembly. Quite often it is a cassette problem. The two winding reels run on ...
Error message E4 and stuck tape vcr is displaying error E4 and when I eject the tapes, the casset makes it out, but is stuck because the tape is still wrapped up inside. Is this fixable? Yes with care
...correct this? The problem is in the idler assembly it is not reeling the tape back into the cassette when it goes into the eject mode, the assembly will need to be replaced and the drive belt
...bar to lower it, tape came ouit. Now, try to insert tape, it would go in. Be sure no foreign object is in the tape well. The other possibility is that the carriage assembly needs ...
tape removal... can break stuff, or perhaps get the gear timing fouled up. Take the top cover off, look for broken pieces of this assembly. If this assembly has gears on the right side, this obviously
break the tape to remove it. you may just need to clean the pinch roller assembly, or it may need replacing. depending on the model number there are repalcement pinch rollers and other parts available
3 questions posted
Usually answered in minutes!
2,410 Questions
1,124 Questions
809 Questions
789 Questions
510 Questions