...test bench it can be about 2 hours of work. Because the factory service setup was not meant for consumer use, it is possible to over adjust parameters to the point where you can lock the set out of ...
...factory default? OK. I fixed it! I'm not sure 100% what did it, but think you'll get it to work with the following. I followed the instructions on how to get the TV set into "test" mode, that were ...
Question about Vizio Televison & Video
...test and nothing, checked the fuses and capacitors and they look to be ok. Would it be best to replace the PSU, the main board or could it be something else such as the screen itslef? Fault at its ...
factory settings. Her only solution was to take the set in for 'service' and see if the TV repair area could do anything (which would invlove a service repair charge). Anyone have info on how to reset
...test by holding the input and menu putting and got a code 22. Please don't tell me i screwed it up by switch the satellite box settings to 1080p! It just blew it's power supply. There could be a fuse ...
factory fuse. Or if someone else as been inside before me.All I had was A 1amp to test it with.I ohm the power cord does not show to be shorted. What would be the next step in trouble shooting? Before
Question about JVC Televison & Video
...test.I give this 50/50 chance of clearing it up. Disconnect the power cord for 4 hours. Then when you power it back up the internal soft codes will automatically reset to factory defaults. Goodluck, ...
factory default settings as a start then turn all your colour off & get the best black & white picture you can take a flick around the channels so that you don't just set to one picture as the bbc don
Question about Televison & Video
factory settings & got off. Remote is not working.. We are operating TV manually.. How to get back TV through remote.. Check the remote control for its infrared emission. Check it with fresh batteries
...factory data do anyone know what the problem is you need to get the service manual for your tv the microcomputer needs to be replace use the test mode from off your remote control enter the numbers ...
2 questions posted
Usually answered in minutes!
1,031 Questions
445 Questions
373 Questions
357 Questions
327 Questions